Table of Contents
Advertisement
Panel Mount Configuration
A cutout should be made in the panel of at least 2.2 x 1.7 inches, (56 x
43mm) but no larger than 2.6 x 2.0 inches (66 x 50 mm).
Install the readout by screwing the four screws in the each corner of the front
case directly into the panel.
The rear half of the readout case is not
necessary when it is used in a panel mounted configuration with a panel of
sufficient thickness to hold the 4 mounting screws. If your panel is too thin to
hold screws, you may 'sandwich' the panel between the front and rear halves
of the readout case and install 4 screws long enough to extend through the
entire assembly and into the rear half case of the readout.
2.5
Inches
2.0 Inches
Cut out size
Accurate Technology DigiScale Models 18 & 28 User Manual
Page 25 of 36
Advertisement
Table of Contents
