Table of Contents
Advertisement
The LCD
The above figure illustrates all the segments on the LCD display.
(Not all segments are used on Compact Readouts)
Changing the Battery
A low battery indicator will appear in the lower left corner of the screen on the
readout when a new battery is needed.
To replace the battery, remove the 4 screws in the corners of the readout
case. Separate the two cases, remove the battery clip and the old battery.
Install a new CR123 3V, or equivalent, Lithium battery, noting the proper
orientation. Replace the battery clip and rear case half, and reinstall the 4
screws.
Battery Clip
-
+
Calibration
There is no calibration available or necessary for the Compact readout.
System accuracy will depend on the accuracy, and quality of the installation,
of the Digi measuring system it is used with.
Manual Part # 800-1404-001, Rev B
Page 26 of 36
Advertisement
Table of Contents
