DATUM KEY
The
key is used to change the currently displayed value.
DATUM
Momentarily pressing the
programmed value. This can be zero or any other displayable value.
See Section 4: Programming,
The
key can also be locked out to prevent accidental entries.
DATUM
See Section 4: Circuit Board Jumpers,
Additional functions of the
Press and hold
Press and hold
Press and hold
Manual Part # 800-1404-001, Rev B
DATUM
Programming Parameter Pr1
DATUM
for 7 seconds to display the firmware version.
DATUM
for 9 seconds to enter programming mode.
DATUM
for 3 seconds to exit programming mode.
DATUM
Momentarily press
key forces the readout to a user
JP 2
Press & Hold
key:
Page 30 of 36