Table of Contents
Advertisement
better resolution, switch to 1/32 or 1/64 mode. For the best resolution and
accuracy switch to a decimal mode – inches or millimeters.
When the measurement is greater than 99 63/64 inches, a +100
+200 will illuminate in the upper right portion of the display to indicate this
+200
+200
+200
amount must be added to the displayed reading. ie: If the measurement is
154 5/8 inches, 54 5/8 and +100
measurement is -307 23/64 inches, - 7 23/64, +100
illuminated on the display.
+
-
AND
KEYS
The
+
(plus) and
position to a different value.
Momentarily depressing the
of measurement. Momentarily depressing the
position by one unit. Pressing and holding the
displayed position to change continuously. Holding down the key will cause
the amount of change to speed up. This allows for quick adjustments over a
range of large values.
DATUM KEY
The
key forces the readout to display a user programmed value.
DATUM
See Section 3: Programming,
NOTE: While the
displayed value, it can also be programmed to force the readout to a preset
value. This can be zero, or any other displayable value.
Readout Functions
REVERSE READINGS
Reverse readings means changing the direction of readings produced by
moving the encoder. If the readout decrements (reduces or goes negative)
when it should be incrementing (increasing or going positive), the readout will
need to be re-programmed for your application.
See Section 3: Programming,
Accurate Technology DigiScale Models 18 & 28 User Manual
+100 will be illuminated on the display. If the
+100
+100
–
(minus) keys are used to change the currently displayed
+
key increments the current position by one unit
Programming Parameter Pr1.
key can be used to simply "zero" the currently
DATUM
Programming Parameter Pr2.
+100 and +200
+100
+100
–
key decrements the current
+
or
–
keys will cause the
Page 19 of 36
+100 and/or
+100
+100
+200 will be
+200
+200
Advertisement
Table of Contents
