Table of Contents
Advertisement
Programming Parameters
The Digi readout programming parameters are listed below.
Values in [ ] are the available range of values that can be entered for that
parameter. Factory defaults are shown in
Pr 1 – Datum Key Value
The programmed value that will be recalled whenever the
pressed during normal operation.
Default = 0.00
Pr 2 – Reading Direction
This parameter controls the direction of travel (positive vs. negative) when
the encoder is moved.
Default = 0
Pr 3 – Key Lockout
This parameter controls the operation of the +,
If enabled, (set to 1), these keys will not function and the LOCK
appear on the display. This prevents accidental changes when pressing
these keys during normal operation.
Default = 0
Pr 4 – Resolution
This parameter sets the number of places to the right of the decimal point on
the readout.
A value of 1 – Low - will display x.x.
A value of 2 – Normal - will display x.xx
A value of 3 – High - will display x.xxx
Default = 3
NOTES:
Millimeters have a maximum of 2 places (even if parameter is set to 3.)
This setting has no effect when displaying fractions.
Accurate Technology DigiScale Models 18 & 28 User Manual
Bold
[0
to + 999.999in] or
-
Red.
[0
to +9999.99mm]
DATUM
[0
or 1]
[0
or 1]
and
keys.
DATUM
LOCK symbol will
LOCK
LOCK
[1, 2,
3
or 4]
Page 23 of 36
key is
Advertisement
Table of Contents
