Table of Contents
Advertisement
Programming
Several functions of the Digi readout are user programmable. The following
describes what features and functions are available and how to change the
factory defaults to customize your DigiScale system.
To enter Programming Mode:
1. Press and hold the
2. The LCD will briefly display: PG on (Programming On), then
Pr 1, (indicating Programming Parameter #1)
3. Release the
4. The value stored in
Once in the Programming Mode:
Moving up parameter list: Momentarily press the
through the Programming Parameter list. The Parameter number is displayed
first, then the current value for the parameter.
Moving down parameter list: Press and hold the
momentarily press the
Programming list.
Increase parameter value - Momentarily press the
displaying a Programming Parameter Value to increase the setting.
Decrease parameter value - Momentarily press the
displaying a Programming Parameter Value to decrease the setting.
Reset parameter value to default setting - Momentarily press the
while displaying a Programming Parameter Value to reset the parameter to
the factory default value.
Exit programming mode - Press and hold the
depress the
DATUM
Off), then return to normal operation.
NOTE: The system will automatically exit programming mode after 60
seconds of no key activity.
Manual Part # 800-1404-001, Rev B
key then momentarily press the
UNITS
key
UNITS
Pr1
is displayed.
Press & Hold
UNITS
key. The LCD will briefly display: PG oFF (Programming
key to move backward through the
UNITS
DATUM
Momentarily press
key to advance
UNITS
/
ON
OFF
(+)
key while
PLUS
(-)
key while
MINUS
DATUM
key. Momentarily
Page 22 of 36
key.
key, then
key
Advertisement
Table of Contents
