Table of Contents
Advertisement
NOTES:
1. Offsets are stored when leaving the Incremental mode. Any offsets
will be recalled the next time you switch from Absolute to Incremental
mode.
2. While in Incremental mode, the Units of Measurement cannot be
changed. If the display is reading mm when you enter the INC mode
you cannot change to inches without first returning to the ABS mode.
KEY LOCK
The user can lock-out the operation of the
prevent accidental changes of the currently displayed value.
To lock these keys set
See Section 4: Programming,
RESOLUTION
The readout can be configured to display measurements in any of three
different resolutions.
1. Low– the resolution is:
2. Normal– the resolution is:
3. High– the resolution is:
The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64
See Section 4: Programming,
RESTORE READOUT TO FACTORY SETTINGS
Remove the battery. Press and hold
Manual Part # 800-1404-001, Rev B
Programming Parameter Pr3 =1
Programming Parameter Pr3
Programming Parameter Pr4
IN
+,
DATUM
.1in or .1mm.
.01in or .01mm.
.001in or .01mm
/
key while reinstalling the battery.
MM
–
and
key functions to
Page 32 of 36
Advertisement
Table of Contents
