Table of Contents
Advertisement
S
1
ECTION
Introduction
DigiScale is a general purpose linear measuring system It consists of three
major parts: a
SCALE
DigiScale is an ideal choice for most measuring requirements up to 60 inches
where affordable digital precision (better than a tape measure) is desired.
Because DigiScale shows the exact measurement on its readout, it
eliminates the ambiguity and mistakes involved when reading and
interpreting tape measures, scales & pointer, or shaft encoders.
Because DigiScale is a solid-state electronic device there's very little to wear
out. The encoder and scale are designed to withstand shop dirt, dust, and
other airborne contaminants. With normal care, DigiScale will last for years.
About This Manual
This manual includes theory and
Models 18 & 28 Scales and Encoders.
This manual includes
Compact Readouts used with DigiScale systems.
Manual Part # 800-1404-001, Rev B
, an
and a
ENCODER
O
PERATION
Digi Readout Part # 700-1600-D55
With Firmware Version d 2.xxx & higher
(Firmware version is displayed on power-up)
2AA alkaline batteries
Side input
Compact Readout Part # 700-1600-710
With Firmware Version b 2.xxx & higher
(Press and hold the
display the firmware version.)
1 CR123 Lithium battery
Rear input
Surface or panel mount
G
ENERAL
DIGITAL READOUT
I
information for DigiScale
NSTALLATION
information for the Digi and the
DATUM
I
NFORMATION
.
key for 7 seconds to
Page 6 of 36
Advertisement
Table of Contents
