Table of Contents
Advertisement
The LCD
The above figure illustrates all the segments available on the LCD
/
Pressing and holding the ON
and UNITS key for 10 seconds with
OFF
power OFF will perform a full segment LCD test, display the current
firmware version, AND RESET ALL PROGRAMMING PARAMETERS TO
FACTORY DEFAULT VALUES.
NOTE: The DRO may also be defaulted to original factory settings by
removing the battery and then pressing and holding the
UNITS
key while re-
inserting battery. *
* Internal jumper
JP3
must be set to the Program Enable position to
allow the DRO to be reset to factory defaults as described above.
Manual Part # 800-1405-001, Rev A
Page 10 of 20
Advertisement
Table of Contents
