1.8.5
COM3 RS 232/422/485 mode selector (JSETCOM3)
Users can use JSETCOM3 to select among RS 232/422/485 modes for COM3. The
default setting is RS 232.
Table 1.5: COM3 RS 232/422/485 mode selector (JSETCOM3)
Function
*RS232
RS422
RS-485
*: Default
1.9
System Memory
The AIMB-567 has two sockets for 240-pin SODIMMx2. All these sockets use 1.8 V
unbuffered double data rate synchronous DRAMs (DDR3 SDRAM). They are avail-
able in capacities of 1024 MB. The sockets can be filled in any combination with
DIMMs of any size, giving a total memory size on 4 GB. AIMB-567 does NOT support
ECC (error checking and correction).
1.10
Memory Installation Procedures
To install SODIMMs, first make sure the two handles of the SODIMM socket are in
the "open" position. i.e. The handles lean outward. Slowly slide the SODIMM module
along the plastic guides on both ends of the socket. Then press the SODIMM module
right down into the socket, until you hear a click. This is when the two handles have
automatically locked the memory module into the correct position of the SODIMM
socket. To remove the memory module, just push both handles outward, and the
memory module will be ejected by the mechanism in the socket.
RS232
RS422
Jumper Setting
(5-6) + (7-9) + (8-10) + (13-15) + (14-16) closed
(3-4) + (9-11) + (10-12) + (15-17) + (16-18) closed
(1-2) + (9-11) + (10-12) + (15-17) + (16-18) closed
9
RS485
AIMB-567 User Manual