Table of Contents
Advertisement
Ruckus Wireless ZoneFlex 2925/2942 User Guide | After the Installation (Post-Installation Setup)
WEP Key
Key Index
5
Click Update Settings to save and apply the changes.
A confirmation message appears at the top of this workspace.
6
Click Go back to Wireless Configuration to reopen the previous workspace.
Customizing Wireless WPA Encryption
ALERT
Use of WPA PSK allows automatic key generation based on a single passphrase. WPA-PSK
provides very strong security, but may not be supported on older wireless devices. In some
cases, the older devices can be upgraded with adapters to take advantage of WPA-PSK.
If you configure the hotspot AP with WPA-PSK, some network users will not be able to con-
nect to your hotspot WLAN unless their devices are manually set to WPA-PSK and configured
with the same passphrase.
To configure hotspot-specific WPA encryption settings, follow these steps:
1
Open the Web User interface, and click Wireless under Configuration.
2
When the Configure::Wireless::Common workspace appears, click a hotspot-specific
tab.
3
When the Configure::Wireless::Wireless[#] workspace appears, open the Encryption
Method menu and choose WPA.
Enter the key manually according to the Key Entry Method and
Encryption Strength settings.
Choose the index, from "1" to "4", that the WEP key is to be
stored in.
Do not undertake the customizing of these options unless you are an experienced network
administrator or are under the guidance of an IT/support professional.
32
Advertisement
Table of Contents
