Renewing Or Releasing Dhcp; Upgrading The Ap Firmware - Ruckus Wireless ZoneFlex 2925 User Manual

Hide thumbs Also See for ZoneFlex 2925:

Table of Contents

Ruckus Wireless ZoneFlex 2925/2942 User Guide | Managing the Access Point

Renewing or Releasing DHCP

This task should be performed only with guidance from your ISP. It serves as a troubleshoot-

ing technique when DHCP addresses to one or more networked devices prove to be unusable

or in conflict with others.

After logging in to the Web User interface, click Internet under Status.

Review the current settings.

If the current Connection Type is DHCP, you will be able to see the currently-assigned

IP address and subnet mask listed below.

• To force the DHCP server to assign a new IP address to this AP, click Renew DHCP.

This will cause a slight interruption in network service until the new IP address has

been put in use.

• To force the DHCP server to assign new IP addresses to all networked devices at the

same time (including this AP), click Release DHCP. This will cause a temporary

interruption in overall network service.

You can use the Web User interface to check for software updates/upgrades for the firm-

ware built into the AP. You can then apply these updates to the device in one of two ways:

[1] manual updating on an as-needed basis or [2] automating a regularly scheduled update.

Before starting, decide which option you want to take:

• Automate a regularly scheduled update

• Run a one-time manual update right now.

By default, the automatic upgrade option is active, and will check the Ruckus Wireless

update server every 12 hours.

After logging into the Web User interface, click Upgrade under Maintenance.

FIGURE 4-16

Table of Contents

Zoneflex 2942