Installing The Console - ALLEN & HEATH XONE V6 User Manual

172mm (6 3/4")
4x M6 bolt clearance (dia 7mm)
4x shallow screw relief (dia 8mm)
38mm (1 1/2")
51mm (2")
233mm (9 3/16")
XONE:V6 User Guide

Installing the Console

441mm (17 3/8")
Template for plinth cutout
175mm (6 7/8")
445mm (17 1/2")
Rack mount
The console fits into a standard 19" rack system
taking up 4U height. Use 4x M6 bolts with plastic protective cups.
These are usually supplied by the rack manufacturer.
Plinth mount
The console can be mounted in a custom built
plinth or other furniture. Use the cutting template detail shown
here. The dimensions allow for the console cover fixing screws.
Secure with 4x suitably long M6 bolts and nuts. Use protective
cups to protect the console surface.
required to allow for the face plate to cover screws.
Due to the class A topology, lamps and valves used the
console can run slightly warm. Do not obstruct the ventilation
slots above and below the console.
adequate air flow around the unit.
To avoid radiated interference do not install the power
unit closer than 200mm (8") to the console.
To avoid damage to the console circuits do not plug in
the DC power lead while the power unit is turned on.
Do not operate the console with its cover removed.
Do not drill any fixing holes through the console cover.
Shallow reliefs may be
Ensure that there is
23