ALLEN & HEATH XONE V6 User Manual page 33

JP1 JP2
XONE:V6 User Guide
Master Option Jumpers
MASTER PCB
Plug on jumpers set the options required. Plug across the two pins to
set. Plug on to just one pin to remove.
available to be re-used later in the future if needed.
Master output level
The output level with MASTER control at
maximum position and VU meters reading '0' is +4dBu with JP1 and
JP2 fitted. This is the factory default setting. To change this to 0dBu
remove JP1 and JP2. Access these jumpers from below the console.
LEVEL
JP1
JP1
This keeps the jumper
JP2
+4dBu
JP2
0dBu
33