Installing The Console - ALLEN & HEATH XONE 464 User Manual

Installing the Console

The XONE Series features the Allen & Heath Quick Change Connector (QCC) system.
The rear connector pod may be hinged and locked into either of two positions. Rear
connectors allow desktop operation with the control panel sloped at a convenient 15
degrees. Underside connectors allow 19" rack mounting in a compact 10U space. The
connector position can be easily changed at any time to fit your application.
To change the
position remove the
crosshead locking
screw on each side,
swing the connector
pod into position, and
refit the two screws
19" Rack or Plinth Mounting
Desktop Operation
XONE:464 User Guide
PRECAUTION :
Do not transport or carry the
console with the locking screws
removed.
Do not attempt to remove the
connector pod from the console.
Mount the console in the
rack using 4x M6 bolts
each side for maximum
strength. We recommend
you fit the bolts with plastic
cup washers to protect the
panel, and they
good... These should be
available from the supplier
of the rack unit or good
hardware store.
Flightcasing
The console can be easily
flightcased in
connector mode.
the dimensions shown here
to your flightcase supplier.
The console is fitted with
rubber feet to ensure it does
not slip or scratch the work
surface. The control panel
is angled at 15 degrees for
operating convenience.
look
either
Provide
13