Internal Option Jumpers - ALLEN & HEATH XONE V6 User Manual

The XONE:V6 provides several user accessible internal jumper options.
specialist application or user preference and should not normally be needed. The factory
default settings should satisfy most applications.
reconfigured quickly. However, it is necessary to remove the console cover to access the
internal circuit assemblies. This requires that the console be unplugged and removed from its
installation furniture. All the jumpers are accessible without removal of any internal assemblies.
Before starting
its rack or furniture.
lighting. Ensure you have a T10 Torx screwdriver to remove the cover screws.
Precautions
process. Ensure the jumpers are pressed fully into position and log your new settings before
refitting the cover.
30

Internal Option Jumpers

Unplug the power unit. Unplug all the cables. Remove the console from
Ensure you have a suitably sized, clean work space with adequate
Take care not to damage the panels or internal assemblies during the
Access to the option jumpers
The jumpers are plug-on and can be
Removing the cover
screwdriver to remove the 4x front plate to cover
fixing screws (M3x6mm). Also remove the 4x
side, 3x top and 3x
(M3x4mm). Carefully slide the cover back over
the rear connector panel to reveal the circuit
assemblies.
These are for
Use a T10 Torx
underside screws
XONE:V6 User Guide