ALLEN & HEATH XONE V6 User Manual page 13

Headphones Controls
The DJ headphones is sourced from the booth mix and switched cue system.
Headphone sockets are provided on both the front and rear panels.
Tone control
This combines the LF and HF equaliser into one, easy to use
TONE
control. At centre position the frequency response is flat. Turning clockwise
boosts the high frequencies while cutting the lows. Turning anti-clockwise
boosts the lows while cutting the highs. Use this to check the frequency make-
up of the music you are cueing in the headphones.
HF
LF
Cue / Mix
This control balances the level of cue signal and booth (music)
CUE/MIX
signal in the headphones. Fully anti-clockwise, only cue signal is routed. Fully
clockwise, only booth mix is routed. At centre position, equal cue and booth
signal is mixed together. Use the control when auditioning new tracks and
experimenting with how they may sound when added to the mix.
Phones level
Controls the overall level of the headphones. It ranges from
CUE MIX
fully off to maximum volume.
5 6
4 7
Headphones are available with different impedance specification, typically
3 8
between 8 and 600 ohms. The XONE:V6 is designed to operate with
2 9
headphones in the range 30 to 600 ohms. For best performance we
1
10 recommend the high quality 70 or 100 ohm type popular with top DJs.
0
11
PHONES
Important Note about Hearing:
To avoid damage to your
hearing do not operate any sound system at excessively high volume. This
also applies to any close-to-ear monitoring such as headphones. Continued
exposure to high volume sound can cause frequency selective or wide range
hearing loss. Make sure that your system complies with any venue sound level
and noise regulations which may apply.
XONE:V6 User Guide 13