Upright Assembly; Rear Base / Seat Assembly - LifeSpan R3 Owner's Manual

C3 UPRIGHT ASSEMBLY
Step 1: Front Base Assembly
Parts Required
Main Frame
Front Base
Hardware Required
Part # Size
A-1 M10 * 90
C-1 M10
Step 2: Rear Base / Seat Assembly
Parts Required
Rear Base
Seat
Hardware Required
Part # Size
A-1 M10 * 90
C-1 M10
Seat
1. Push the seat down all the way onto the seat post spindle.
2. Making sure that the seat points straight forward and is level to the ground, tighten
the two 14 mm nuts on each side of the seat clamp.
Description
Dome Head Allen Screw
Curved Washer
1. Locate the hardware bag for Step 1.
2. Place the front base over the frame aligning
the holes in the base with the threaded holes
in the frame.
3. Insert the two 6 mm dome head screws with
bent washers into the holes in the front base
and tighten screws.
Description
Dome Head Allen Screw
Curved Washer
Rear Base
1. Locate the hardware bag for Step 2.
2. Place the rear base over the frame aligning the
holes in the base with the threaded holes in
the frame.
3. Insert the two 6 mm dome head screws with
bent washers into the holes in the front base
and tighten screws.
15
Quantity
2
2
Quantity
2
2