Table of Contents
Advertisement
Call Forwarding Busy
Call forwarding busy will divert all incoming calls to a phone number that you desire only if your telephone is busy on another call.
To enable Call Forwarding Busy, dial *67*<Directory Number>#
(Where directory number is the number you wish to forward calls to)
1.
Hang up after you hear 2 low pitch beeps.
2.
To disable Call Forwarding Busy, dial #67#
3.
Hang up after you hear 2 high pitch beeps.
4.
To check the status of Call Forwarding Busy, dial *#67# or view the advanced status page of the management console.
(a) Call Forwarding Busy is disabled if you hear 2 high pitch beeps.
(b) Call Forwarding Busy is enabled if you hear 2 low pitch beeps.
Call Forwarding Not Reachable
Call forwarding busy will divert all incoming calls to a phone number that you desire only if your telephone is unreachable by the
network.
1.
To enable Call Forwarding Not Reachable dial *62*<Directory Number>#
(Where directory number is the number you wish to forward calls to)
2.
Hang up after you hear 2 low pitch beeps.
3.
To disable Call Forwarding Not Reachable, dial #62#. Hang up after you hear 2 high pitch beeps.
4.
To check the status of Call Forwarding Not Reachable, dial *#62# or view the advanced status page of the management
console.
(a) Call Forwarding No Answer is disabled if you hear 2 high pitch beeps.
(b) Call Forwarding No Answer is enabled if you hear 2 low pitch beeps.
Conference Call
This can be achieved by performing a hook-flash and then by dialling the third party.
Wait for the third party to answer your call and then perform another hook-flash to conference all the parties together.
Note: In order to activate a conference call, you will need to have originated both calls.
Troubleshooting
What do I do if I have no dial tone?
Please follow the procedure listed below:
1.
Check to make sure the phone is plugged into the line port of the NTC-30WV.
2.
Check to make sure you are using the correct cable (Cat-3 UTP Telephone Cable with RJ-11 plugs).
3.
Check to make sure the 3G signal strength indication lights on the front of the NTC-30WV are lit up.
4.
Check to make sure your 3G SIM card is activated and insert into your NTC-30WV properly.
5.
Check and see if you get the dial tone after rebooting your NTC-30WV.
I have noise interference during telephone calls. How can I fix this?
To resolve this issue, try the following:
1.
Verify that the RJ-11 cable is securely connected and not damaged.
2.
Try to remove any telephone splitters from the connection between your phone and the NTC-30WV.
3.
Try rebooting your NTC-30WV.
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
80
www.netcommwireless.com
Advertisement
Table of Contents
