Table of Contents
Advertisement
8.
Under Wireless Setup, select the same frequency channel as you did for Access Point 1. Enter an SSID to identify Access
Point 2 and set Network Authentication to Open. Copy the Network Authentication and WEP Encryption settings from
Access Point 1. Set Access Point 2 to Repeater mode and enter the MAC address of Access Point 1 in the AP MAC
Address1 field. The MAC address of Access Point 1 is listed on the same page under Wireless Settings > Basic under the
Wireless Distribution System (WDS) section. When you have entered the required information, click Save:
The Wireless Distribution System setup is now complete.
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
50
Figure 52 - WDS – Access Point 2 Repeater Mode Setup
www.netcommwireless.com
Advertisement
Table of Contents
