Inspire M2 Assembly & Operation Manual page 18

Hide thumbs Also See for M2:

Table of Contents

NOTE: Once Assembled, slide rubber

washer against plastic ball

Pulley 13

STEP 15

2 – 3 ½" Pulleys

2 – 3" Hex Bolts

4 – 3/8" Flat Washers

2 – 3/8" Lock Nuts

Step 15:

Begin by running upper cable from back of machine to front

as shown in the diagram. Next, slide pulleys 13 & 14 into the

Press Arm Mount as cable is routed. Secure Press Arm Pulleys using:

Step 16: Assemble Cable End by sliding one plastic ball onto the end of the cable. Next slide the

cable end into the side of the cable "U" bracket. Finally, attach spring clip to "U" bracket using a

1 ¼" shoulder bolt and 5/16" lock nut. Wrench Tighten Now.

Press Arm Mount

Pulley 14

Wrench Tighten Now.

STEP 16

1 – Plastic Ball

1 – Cable "U" Bracket

1 – 1 ¼ " Shoulder Bolt

1 – Spring Clip

1 – 5/16" Lock Nut

NOTE: CABLE GOES INSIDE FRAME TUBE

Page 15

Two (3" Hex Bolts)

Four (3/8" Flat Washers)

Two (3/8" Lock Nuts)

Table of Contents

Show Quick Links

Table of Contents