Inspire M2 Assembly & Operation Manual page 14

Use Small OD Washers on the
Outside of the Press Arm Bearings
STEP 8
4 – 1" Hex Bolts
4 – 3/8" Small OD
Washers
4 – 3/8" Flat Washers
4 – 3/8" Lock Nuts
STEP 9
2 – ½" Button Head Bolts
2 – 3/8" Flat Washers
Press Arm Mount
Step 8: Attach Press Arm Bearings to Top Beam Plates using:
Note: Finger Tighten Only
Step 9: Attach Press Arm Mount to Press Arm Bearings Using:
Note: Finger Tighten Only
Press Arm Bearings
Page 11
Four (1" Hex Bolts)
Four (3/8" Small OD Washers)
Four (3/8" Flat Washers)
Four (3/8" Lock Nuts)
Two (1/2" Button Head Bolts)
Two (3/8" Flat Washers)