Unsent Messages - AMSTRAD E3 e-m@iler User Instructions

Email
Attaching a voice message to your email
You can record a brief voice message on the
message. To do this, compose your email message in the normal way, but carry out
steps 1 and 2 (below) just before you press EMAIL to send the message.
Hold down the RECORD button
1.
(for approx 5 seconds) until the
following display appears (right):
Lift the handset and press 1 – speak after the
2.
beep. When you've finished recording (about
10 seconds max), press STOP and replace
handset.
& Note when recording, you may leave the handset in place and speak into
the microphone at the front right-hand side of the
(Press STOP twice to finish.)
(Note, symbol will appear at top right of display when a voice attachment is added.)
♦ If you wish to delete the voice attachment, press "SHIFT and !DEL.
& Avoid saving and storing messages containing photo and/or voice
attachments as they use up a lot of memory.

Unsent messages

If a message cannot be sent, it may be because:
♦ the line is engaged, or
♦
somebody picked up the phone (or an extension) while sending was in progress
(note that priority is always given to telephone calls), or
♦
the was unplugged from the phone line or couldn't get through to
e-m@iler
Amserve (the service provider may have experienced a temporary service
disruption).
In each of these cases, the
minutes, 2 hours, 8 hours and 24 hours, until the message is sent. (Note that
for email
will be displayed during each attempt.) Redial is automatic – there is no
need for you to take any action yourself. If you wish, you can attempt to re-send the
message manually by holding down the EMAIL button for approx 5 seconds.
e-m@iler
will attempt to re-send the message after 30
e-m@iler
- 60 -
and attach it to your email
instead.
e-m@iler
Dialling