AMSTRAD E3 e-m@iler User Instructions page 129

♦
If you're using the
e-m@iler
number (for example 9) can be set up to be dialled automatically to access an
outside line.
♦
Call Waiting may be available on subscription from your telephone service
provider. (The service allows you to be notified of additional calls while you're
already on the phone.) When used in conjunction with email, Amsurf, games and
ringtones, certain hidden codes are used to disable and re-enable Call Waiting
before and after email or other data calls (this is to prevent any Call Waiting beep
interfering with the data being received). If, for example, you subscribe to BT's Call
Waiting service, the codes entered must be
& Note the
is set for tone dialling and timed break recall. These settings
e-m@iler
are suitable for most UK telephone exchanges. The
with the older (pulse dialling)exchanges or on overseas exchanges.
Press SETUP, 2 so that display top line reads
1.
SET UP - TELEPHONE
2. If you wish to set up the cost saver prefix,
continue to step 3. If not, go straight to step 10.
& You cannot use cost saver if you're on a switchboard extension.
Press 1 so that top line reads
3.
Press 1 to select
Cost
4.
Press 3 so that top line reads
5.
(If necessary, press !DEL to delete any existing digits.)
Type in the required digits for the cost saver tariff (for example 132), then press
6.
STORE.
Press 4 so that top line reads
7.
(If necessary, press !DEL to delete the existing dialling code.)
8. Type in your local dialling code (for example
press STORE.
The cost saver is now in operation (see 'Cost saver notes' on page 129).
in the office as a PABX switchboard extension, a prefix
#43#
LINE:
SET UP - PREFIX.
Saver.
SET UP - COST SAVER.
SET UP - LOCAL CODE.
01234
- 127 -
Advanced settings
✱43#
(disable) and (enable).
cannot be used
e-m@iler
020 or 0121), then
or