Table of Contents
Advertisement
H-Series BF Gas Fireplace
H34BF
Installing the Log Set
Installing the Logs:
Log 'D'
The H-Series BF is supplied with four ceramic fibre logs and a ceramic
fibre logset base. Unpack the logs and handle them very carefully.
Bottom Left Log
Top Left Log
Figure 14a. H-Series BF's five piece logset.
1.
Remove the glass door.
2.
The base log is factory-installed, as shown below in figure 14b.
Figure 14b. Base log placement.
3.
Arrange the ember chips on top of the burner tray. Care should be
taken when placing the ember chips, as blocked burner ports may
cause an incorrect flame pattern, carbon deposits and delayed
ignition. Also, the chips must never be placed in a way that obstructs
any of the air inlet ports, located at the rear of the burner, as shown
in figure 14c.
Air Inlet Ports
Ember Chips
Figure 14c. Ember Chip placement.
Page 8
Installation
Base Log
Bottom Right Log
Top Right Log
Base Log
3.
Place the bottom left and right logs as shown below in figure
14d.
4.
Place the top left and right logs as shown in figure 14e.
Bottom Left Log
Figure14d. Bottom left and right log placement.
Top Left Log
Figure 14e. Top left and right log placement.
5.
Start the fireplace. If the flame appears satisfactory, replace the
glass door. If the flame does not appear satisfactory, double-
check the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
Cautions:
If logs are not placed properly, excessive sooting
■
will result.
The surface of the logs will crack due to the heat from
■
the flames. This is a normal occurrence.
Bottom Right Log
Top Right Log
Part No. XG0145
Advertisement
Table of Contents
