Removing And Installing The Door - Montigo H34BF Installation & Operation Manual

Wiring for the optional Fan Kit
All H-Series BF fireplaces may be equipped with optional fan kits for
circulating heat into the living space.
Installations in Canada which employ the fans must be electrically
grounded in accordance with CSA C22.1 Canadian Electrical Code
Part 1 and/or Local Codes.
Installations in the USA which employ the fans must be grounded in
accordance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70-1987.
For more information see the Fan Kit Installation Guide included with
the fan kit.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
L2-WH
G
L1-BLK
Quick Connect
p g lu to motor
Figure 11. Wiring for optional fans.
115/1/60 Supply
G L1 L2
Figure 12. Wiring schematic for optional fans.
Part No. XG0145
Installation
Removing and Installing
Removing the door:
The door is held in place by a lip on the top of the metal frame and two
buckles at the bottom. Release the buckles and lift the door carefully up
and away from the front of the fireplace. See figures 28a and 28b.
Installing the door:
Hook the top edge of the door frame into place. Lower and rest the door
frame in place and fasten the buckles. See figures 28a and 28b.
Figure 13a. Removing and installing the glass door.
Figure 13b. Removing and installing the glass door.
H-Series BF Gas Fireplace
the Door
Page 7