Installing The Logset - Montigo Hotshot DHS Installation & Maintenance Manual

Installing the Log Set
Installing the Logs:
The double burner Hotshot is supplied with a six (6) piece fibre log
set.
1. Remove the door cover and the glass door.
Back burner tube
Back log
Back log rest
Heat exchanger tubes
Figure 12a. Positioning for the top logs ('C' and 'D' ).
2. Unpack the logs. Be sure to handle the logs carefully, as they are
very fragile.
3. Place the Back log onto the back log rest as shown below in
figure 12a. The log has lip on the bottom which fits into the slot
on the log rest.
4. Place the Front log onto the front log rest as shown in figure
12a. Centre the log from side to side, and push it against the
back of the log rest. Carefully push the log onto the metal spikes
on the log rest.
5. Place the top logs in position as shown in figures 12b and 12c.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Left log
Back log
Center logs
Figure 12b. Proper placement (top view).
XG0511 - 150203
Installation
Ember tray
Front burner tube
Front log
Front log rest
Right log
Front log
Back log
Left log
Figure 12c. Log placement as seen from the front of the stove.
NOTES
If the logs are not placed properly, excessive sooting

will result.
The surface of the logs will crack due to the heat from

the flames. This is a normal occurrence
Hotshot Gas Fireplace Insert
Center logs
Right log
Front log
:
Page 13