Section 9: Installing The Accessories; Installing The H38Pr* Logset - Montigo H38DF PRC Installation & Maintenance Manual

H*38DF PRC Panorama Indoor Gas Fireplace
Section:

Section 9: Installing the Accessories

Installing the H38PR* Logset

The H38PR* is supplied with eight (8) fibre logs. The two small
bottom logs ("A" ) are mounted on the burner grate by placing
them diagonally onto the supplied Log stands. The long Front /
Back logs ("B") are placed against the grate as shown in Figure
27b. Note: When placing logs, arrange Logs "B" as not to cover
Burner holes.
Next are the Top logs "C" which are placed diagonally, as shown
in Figure 27c. The last logs "D" is then mounted on top of logs
"A" as shown in Figure 27d.
Installing the Ember Material
The ember material is supplied in two packages. Spread the material
evenly around the burner tray, or pile around burner holes for a
realistic effect.
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
Log Stand
Front of Fireplace
Figure 27. Empty firebox showing the Left & Right stands.
Log A
Figure 27a. Place Logs' "A" on Left & Right stands.
Log B
Figure 27b. Place Logs' "B" as shown, in front of Right-hand
"A", and behind Left-hand "B".
Page 26
Installation
Log Stand
Burners
Log A
Log B
Log C
Figure 27c. Log Installation. Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Log D
Figure 27d. Completed Installation.
NOTICE
If logs are not placed properly, excessive sooting will result.
NOTICE
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
NOTICE
Do not operate this fireplace without the glass door or with a broken glass door.
Log C
Log D
XG0211 - 151126