Table Of Contents; Introduction - Montigo H34BF Installation & Operation Manual

H-Series BF Gas Fireplace

Table Of Contents

Introduction .............................................................................. 2
Installation
Installing and Framing the Fireplace .............................. 3
Installing the Gasline ...................................................... 4
The Remote Switch ........................................................ 4
Direct Vent Installation ................................................... 4
General Venting Requirements ......................... 4
Terminations ...................................................... 5
Converting to Top or Rear Vent model .............. 5
Venting for Top Vent models .............................. 6
Venting for Rear Vent models ............................ 9
Construction around the fireplace
Facing .............................................................. 11
Mantels and Surrounds ................................... 11
Wiring ......................................................................... 11
Installing Optional Fans................................................ 11
Removing and Installing the Door ................................ 12
Installing the Logset ..................................................... 13
Installing the Horizontal Trim ........................................ 13
Operation .........................................................................14 - 16
Maintenance ....................................................................16 - 17
Warranty ................................................................................. 18
Appendix
A. Termination Locations .............................................. 19
CAUTIONS
Due to its high operating temperatures, the appliance
should be located out of traffic & away from furniture
and draperies.
Children and adults should be alerted to the hazards
■
of the high surface temperature, which could cause
burns or clothing ignition.
Young children should be carefully supervised when
■
they are in the same room as the appliance.
Clothing or other flammable materials should not
■
be placed on or near the appliance.
Page 2

Introduction

Thank You for choosing a Montigo Gas Fireplace.
About this Fireplace:
The H-Series BF is a fireplace with a pan-style burner and glowing
embers. This fireplace is available in two models.
The H34BF is rated for Natural Gas at 18,000 BTU/H (5.28 Kilowatts)
Input or Propane at 18,000 BTU/H (5.28 Kilowatts) Input.
H34BF; Top Vent, Millivolt Pilot.
■
H34BF-I; Top Vent, Intermittent Pilot (HSI).
■
H34BF-A; Top Vent, Electronic Ignition (American Flame).
■
The H38BF is rated for Natural Gas at 26,000 BTU/H (7.62 Kilowatts)
Input or Propane at 26,000 BTU/H (7.62 Kilowatts) Input.
H38BF; Top Vent, Millivolt Pilot.
■
H38BF-I; Top Vent, Intermittent Pilot (HSI).
■
H38BF-A; Top Vent, Electronic Ignition (American Flame).
■
The H42BF is rated for Natural Gas at 34,000 BTU/H (9.97 Kilowatts)
Input or Propane at 28,000 BTU/H (9.97 Kilowatts) Input.
H42BF; Top Vent, Millivolt Pilot.
■
H42BF-I; Top Vent, Intermittent Pilot (HSI).
■
H42BF-A; Top Vent, Electronic Ignition (American Flame).
■
How to use this manual:
This manual covers installation, operation and maintenance. Lighting,
operation and care of this fireplace can be easily performed by the
homeowner. However, all installation and service work should be
performed by a qualified or licensed installer, plumber, or gasfitter who
is qualified or licensed by the state, province, region, or governing body
in which the appliance is being installed.
This manual covers all models and unless otherwise specified, the
designation H-Series BF refers to all models. Sections which are
specific to a particular model are marked with a
the appropriate model number.
Warranty and Installation Information:
The Montigo warranty will be voided by, and Montigo disclaims any
responsibility for, the following actions:
Modification of the fireplace and/or components including Direct-Vent
■
assembly or glass doors.
Use of any component part not manufactured or approved by Montigo in
■
combination with this Montigo fireplace system.
Installation other than as instructed in this manual.
■
Consult your local Gas Inspection Branch on installation requirements
for factory-built gas fireplaces. Installation & repairs should be done by
a qualified contractor.
Installations in Canada must conform to the current CAN/CGA B-
149.1 and .2 Gas Installation Code and local regulations. If the optional
air-circulating fan kit is installed, it must be electrically grounded in
accordance with CSA C22.1 Canadian Electrical Code Part 1 and/or
Local Codes.
Installations in the USA must conform to local codes, or in the absence
of local codes to the National Fuel Gas Code, ANSI Z223.1-1988. If the
optional air-circulating fan is installed, it must be grounded in accordance
with local codes or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70-1987.
symbol, plus
Part No. XG0145