Using The Faceplate - Grizzly G0492 Owner's Manual

Using the Faceplate

To install the faceplate:
Mounting the Chuck and Faceplate
Page 17
To load a workpiece:
1
2.
3.
4.
Note: Depending on the workpiece, some
additional support may be needed.
5.
Make sure your clamping application will
not fail!
6.
Securely clamp your workpiece
and remove the chuck key!
Thrown objects from a lathe/
mill can cause serious injury
or death to the operator and to
bystanders many feet away.
Figure 16.
Use a minimum of three independent
clamping devices when turning eccentric
workpieces. Failure to provide adequate
clamping will cause workpiece to eject.