Installing/Removing Faceplate - Grizzly T32536 Owner's Manual

Installing/Removing
Faceplate
These instructions cover installing and removing
the faceplate. To mount a workpiece to your face-
plate, refer to Faceplate Turning on Page 26.
Tools Needed
Open-End Wrench 19/27mm ............................. 1
Knockout Tool .................................................... 1
Installing Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. While holding spindle in place, thread face-
plate clockwise onto spindle shaft until secure
against shoulder on spindle shaft.
3.
Insert knockout tool into one hole on spindle,
then tighten faceplate with open-end wrench
(see Figure 18).
Figure 18. Installing faceplate on spindle.
-22-
Qty
Faceplate
Removing Faceplate
1.
DISCONNECT MACHINE FROM POWER!
2.
Put open end of wrench over flats behind
faceplate. While holding spindle in place with
knockout rod, turn wrench counterclockwise
until faceplate is removed (see Figure 18).
Note: If spur center is installed, it will be
removed during this process.
To prevent faceplate and workpiece sepa-
rating from spindle during operation, head-
stock faceplate MUST be firmly threaded
onto spindle. If these instructions are not
properly performed, serious personal injury
could occur.
Model T32536 (Mfd. Since 10/20)