Table of Contents
Advertisement
Headstock Faceplate
Installing Faceplate
To install faceplate:
1.
DISCONNECT MACHINE FROM POWER!
2.
Rotate spindle lock right to prevent spindle
from turning while you tighten faceplate, as
shown in Figure 36.
Figure 36. Locking spindle to install faceplate.
To prevent faceplate and workpiece sepa-
rating from spindle during operation, head-
stock faceplate MUST be firmly threaded
onto spindle and secured in place by fully
tightening the two faceplate set screws.
If these instructions are not properly per-
formed, serious personal injury could occur.
-34-
3.
Thread faceplate onto spindle until it is snug
(see Figure 37).
4.
Tighten (2) M6-1 x 10 set screws along inside
diameter of faceplate to secure it to spindle
(see Figure 37).
Spindle
Lock
Figure 37. Location of faceplate set screws.
Note: To remove faceplate, disconnect lathe from
power source and perform steps above in reverse.
5.
Rotate spindle lock left to unlock spindle.
Never resume turning operations without
making sure that spindle lock is disengaged
and spindle turns freely by hand. Otherwise
personal injury or property damage could
result.
Faceplate
Set Screws
Model G0799 G0800 (Mfd. Since 11/17)
Faceplate
Advertisement
Table of Contents
