Using The Centers - Grizzly G0492 Owner's Manual

12" x 36" combo lathe/mill
Hide thumbs Also See for G0492:
Table of Contents

Advertisement

Using the Centers

To install a dead or live center:
1.
Figure 24.
2.
3.
Note: Make sure there is a center drilled hole
in the end of the workpiece for the dead cen-
ter.
4.
5.
Figure 24
To install the MT#5 dead center in the spin-
dle:
1.
2.
3.
4.
Figure 25
Note: When using the dead center in the
spindle, use a lathe dog so that your part will
rotate with the spindle and not spin on the
dead center tip.
Figure 25.
NOTICE
Failure to keep dead center point well
lubricated will gall the dead center and
workpiece.

Advertisement

Table of Contents
loading

Table of Contents