Using The Mill Table - Grizzly G0492 Owner's Manual

Positioning the
Headstock
To position the spindle head vertically:
1.
2.
Figure 41
3.
Figure 41.
The headstock is heavy. Make sure that
you support the headstock before you
loosen the lock nuts. Ignoring this warning
may allow the headstock to uncontrolla-
bly swing over to the right or left causing
injury or severe lathe/mill damage.
4.
Figure 41
Figure 42
Figure 42.

Using the Mill Table

Setting Power Feed Rate
Page 29.
Cross Slide
Longitudinal Feed Control
Figure 43.
Figure 43
Figure 43