Installing Faceplate - Grizzly G0838 Owner's Manual

5. Make sure center of quill lock handle is
aligned with quill keyway to ensure tailstock
center and quill will not freely rotate under
load (see Figure 23).
Figure 23. Quill lock handle aligned with quill
keyway (center not shown for clarity).
6.
Secure quill in place by retightening quill lock
handle.
Removing Tailstock Center
1.
Loosen quill lock handle.
2.
Hold a clean rag under spindle or wear a
glove to catch center when you remove it.
3. Rotate handwheel
tailstock quill will retract back into quill, caus-
ing center to be forced out.
Tailstock quill must always be locked in
place during lathe operation. Before tight-
ening quill lock handle, it must be prop-
erly aligned with quill keyway. Otherwise,
workpiece can be thrown from lathe caus-
ing serious personal injury or death.
Model G0838 (Mfd. Since 10/17)
Quill Lock Handle
Quill Keyway
counterclockwise—

Installing Faceplate

These instructions cover removing and installing
the faceplate. To mount a workpiece to your face-
plate, refer to Faceplate Turning on Page 30.
Tools Needed
Indexing Pin ....................................................... 1
Hex Wrench 3mm .............................................. 1
Knockout Tool .................................................... 1
Removing Faceplate
1.
DISCONNECT MACHINE FROM POWER!
2.
Insert included indexing pin into an indexing
hole (see Figure 24) and rotate spindle until
pin engages, preventing spindle from turning.
3.
Loosen (2) set
(see Figure 24).
Figure 24. Inserting indexing pin.
Qty
screws on faceplate
Indexing
Pin
Faceplate Set
Screw (1 of 2)
-25-