Operation
Programming (Cont.)
Program Upload
Reset
Default Values
Whites Setting
bcLORado™ Batten 72 Tour User Manual Rev. 01c
This option allows the user to copy the custom programs of one COLORado™ Batten
72 Tour fixture onto other COLORado™ Batten 72 Tour fixtures by using the
Master/Slave method
1) Configure and connect the fixtures in a Master/Slave arrangement, where the
master unit has the custom programs you want to transfer onto the slave units.
2) At the master unit, press <MENU> repeatedly until SETTINGS shows, and press
<ENTER> to accept.
3) Use <UP> or <DOWN> to select UPLOAD and press <ENTER> to accept.
4) When prompted, enter the master access password as shown in Control Panel
Lock.
5) When SEND shows, press <ENTER> to start the upload.
6) Wait for the upload process to finish before disconnecting the fixtures.
During and after the upload, the master and slave units will visually indicate the
status of the process, as follows:
Yellow means that the upload is running.
Red means that the upload failed due to an error.
Green means that the upload completed successfully.
This setting allows the user to reset the COLORado™ Batten 72 Tour fixture to its
default values, including the custom programs.
1) Press <MENU> repeatedly until SETTINGS shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select RESET, and press <ENTER> to accept.
3) When prompted, enter the master access password as shown in Control Panel
Lock.
4) Wait for the reset process to finish.
Parameter
Default Value
STATIC
ADDRESS
RUN
PERSON
ID
ID ON/OFF
This setting allows the user to select and edit the temperature of the white colors used
in channel 7 (Macros) when in the TOUR mode. It also allows the user to define the
maximum RGB values when RGB to White is active.
1) Press <MENU> repeatedly until CALIB shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select a white color (WHITE 1~11) or RGB TO W.
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select a color (RED, GREEN, BLUE, WHITE, .AMBER).
5) Press <ENTER> to accept.
6) Use <UP> or <DOWN> to select a color value (0~255).
7) Repeat for the other colors.
8) Press <MENU> to exit once done.
When selecting RGB T O W , you will only be able to define the values of RED,
GREEN and BLUE.
The values of RED, GREEN and BLUE configured from CALIB > RGB T O W will
define the color temperature shown when the RGB faders are set to "255" if
COLOR > RGB TO W is active.
-12-
Parameter
DIMMER
000
COLOR
001
EDIT
DMX
FANS
TOUR
KEYLOCK
001
ON
Default Value
DIM4
OFF
000
AUTO
OFF
March 3, 2010