Control Panel Lock; Program Upload; Reset - Chauvet COLORado Batten 72 Tour User Manual

Control Panel
Lock

Program Upload

Reset

COLORado™ Batten 72 Tour User Manual Rev. 4
This setting enables you to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the product's settings.
1. Go to the KEYLOCK main level.
2. Select ON or OFF.
When the control panel lock is active, the product will prompt you to enter the
password after 30 seconds of control panel inactivity or after turning on the product.
After being prompted to enter the password:
Press <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This option allows you to copy the custom programs of one COLORado™ Batten 72 Tour
onto other COLORado™ Batten 72 Tours by using the Master/Slave mode.
1. Configure and connect the products in a Master/Slave arrangement, where the master
product has the custom programs you want to transfer to the slave products.
2. From the master product, go to the SETTINGS main level.
3. Select UPLOAD, press <ENTER>.
4. When PASSWORD shows, enter the master access password as shown in
Panel Lock.
5. When SEND shows, press <ENTER> to start the upload.
6. Wait for the upload process to finish (the display will show END/MAIN) before
continuing or turning the products off.
The Master/Slave products will provide the status of the process by lighting up as
follows:
· Yellow indicates that the upload process is running.
· Green indicates that the upload process completed successfully.
· Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact CHAUVET®
Technical Support.
DO NOT upload the data from a COLORado™ Batten 72 Tour to a different product.
The other product may become inoperative.
This setting allows you to reset the COLORado™ Batten 72 Tour to the default values,
including the custom programs.
1. Go to the SETTINGS main level.
2. Select RESET.
3. When PASS shows, press <ENTER>.
4. Enter the master access password as described in
5. Wait for the reset process to finish.
Operation
Control Panel Lock.
Control
-11-