Control Panel Lock; Program Upload - Chauvet COLORado Range IP User Manual

Control Panel Lock

Program Upload

COLORado™ Range IP User Manual Rev. 06
This setting enables the user to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the product's settings.
1. Go to KEY.
2. Select ON or OFF.
When the control panel lock is active, the product will prompt the user to enter the
password after 30 seconds of control panel inactivity or after turning on the product.
After being prompted to enter the password:
1. Press <UP>, <DOWN>, <UP>, <DOWN>, and <SET>.
This option enables the user to copy the custom programs of one COLORado™ Range IP
unit onto other COLORado™ Range IP units by using the Master/Slave method.
1. Configure and connect the units in a Master/Slave arrangement, where the master
unit has the custom programs you want to transfer onto the slave units.
2. At the master unit, go to SET.
3. Select UPLD.
4. When PASS shows press <SET>.
5. Enter the master access password as shown in Control Panel Lock.
6. When SEND shows, press <SET> to start the upload.
7. Wait for the upload process to finish (the display will show END before continuing or
turning the units off.
The master and slave units will provide the status of the process by lighting up as
follows:
 Yellow indicates that the upload process is running.
 Green indicates that the upload process completed successfully.
 Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact Chauvet
Technical Support.
DO NOT upload the data from a COLORado™ Range IP to a different product. The
other product may be become inoperative.
Operation
-11-