Colorado™ Batten 72 Tour Troubleshooting Guide - Chauvet COLORado Batten 72 Tour User Manual

Colorado batten 72 tour
Hide thumbs Also See for COLORado Batten 72 Tour:
Table of Contents

Advertisement

COLORado™ Batten 72 Tour Troubleshooting Guide
Symptom
General low light intensity
A single LED (R, G, B, W
or A) does not illuminate
A group of LEDs (R, G, B,
W or A) does not
illuminate
None of the LEDs in a
module are illuminating
Breaker/Fuse keeps
blowing
Fixture does not power up
Fixture does not respond
to DMX
DMX signal problems
March 3, 2010
Cause(s)
Dirty lens assembly
Misaligned lens assembly
Faulty LED
Faulty LED board
Faulty LED
Faulty LED board
Faulty LED driver
Faulty LED board
Faulty LED Driver board
Faulty Display/Main board
Excessive circuit load
Short circuit along the power wires
No power
Loose or damaged power cord
Blown fuse
Faulty internal power supply
Wrong DMX addressing
Damaged DMX cables
Wrong polarity on the controller
Loose DMX cables
Faulty DMX interface
Faulty Display/Main board
Non DMX cables
Bouncing signals
Long cable / low level signal
Too many fixtures
Interference from AC wires
If you still experience technical problems after trying the above solutions, contact
CHAUVET® Technical Support.
Technical Information
Action(s)
Clean the fixture regularly
Install lens assembly properly
Replace the LED board
Replace the LED board
Replace the LED Driver board
Replace the LED board
Replace the LED Driver board
Replace the Display/Main board
Check total load placed on the electrical circuit
Check for a short in the electrical wiring
Check for power on power outlet
Check power cord
Replace fuse
Replace internal power supply
Check Control Panel and unit addressing
Check DMX cables
Check polarity switch settings on the controller
Check cable connections
Replace the Display/Main board
Replace the Display/Main board
Use only DMX compatible cables
Install terminator as suggested
Install an optically coupled DMX splitter right after
the fixture with the strong signal
Install an optically coupled DMX splitter after unit
#32 or before
Keep DMX cables separated from power cables or
fluorescent/black lights
-19-
COLORado™ Batten 72 Tour User Manual Rev. 01c

Advertisement

Table of Contents
loading

Table of Contents