Dmx Control With Id Addressing; Static Color; Auto Programs; Edit Customs - Chauvet COLORado Batten 72 Tour User Manual

Operation
Programming (Cont.)
DMX Control With ID
Addressing

Static Color

Auto Programs

Edit Customs

bcLORado™ Batten 72 Tour User Manual Rev. 01c
In this mode, the fixtures with the same DMX starting address will respond to the DMX
controller based on the fixture's individual ID address setting. If the user selects ID
address "0", all the fixtures with the same DMX address will respond in unison.
Otherwise, each fixture will follow the control for its particular ID address.
1) Repeat steps 1, 2 and 3 from DMX Control Without ID Addressing.
2) Activate ID Addressing in each fixture:
a) Press <MENU> repeatedly until SETTINGS shows, and press <ENTER> to
accept.
b) Use <UP> or <DOWN> to select ID ON/OFF and press <ENTER> to accept.
c) Use <UP> or <DOWN> to select ON, and press <ENTER> to accept.
d) Press <MENU> twice to return to the main level.
The Static Color mode allows for permanent RGBWA color mixing without a DMX
controller.
1) Press <MENU> repeatedly until STATIC shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired color (RED, GREEN, BLUE, WHITE or
AMBER).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired color value (0~255).
5) Press <ENTER> to accept.
6) Repeat for the other colors.
7) Use <UP> or <DOWN> to select STROBE, and press <ENTER> to accept.
8) Use <UP> or <DOWN> to select the desired frequency (0~20).
9) Press <MENU> twice to return to the main level.
Auto programs allow for dynamic RGBWA color mixing without a DMX controller.
1) Press <MENU> repeatedly until AUTO shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (AUTO 01~10 or
CUSTOM 01~10).
3) Press <ENTER> to accept.
You cannot edit any of the auto programs (AUTO 01~10). However you can edit
custom programs CUSTOM 01~10 (see Edit Customs).
This setting allows the programming of up to 30 scenes for each of the 10 customizable
programs, including colors and effects.
1) Press <MENU> repeatedly until EDIT shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (CUSTOM 01~10).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired scene (SCENE 01~30).
5) Press <ENTER> to accept.
6) Use <UP> or <DOWN> to select the desired color or effect (RED, GREEN, BLUE,
WHITE, AMBER, STROBE, TIME or FADE) and press <ENTER> to accept.
7) Use <UP> or <DOWN> to adjust the color or effect (000~255 for colors and timers,
or 00~20 for Strobe) and press <ENTER> to accept.
8) Repeat for the other colors or effects.
9) Press <MENU> to return to the SCENE level (step "4").
10) Repeat for the other scenes.
11) Press <MENU> to return to the main level once done.
-10- March 3, 2010