Setup - Danish Interpretation Systems DCS 600 User Manual

Danish Interpretation Systems
Symbols
The following symbols are used on the LCD
display:
'-'
The dash symbol ('-') preceding a line of text
identifies a submenu or a changeable parameter.
The submenu or parameter can be selected by
pressing the corresponding select button.
'>'
The '>' symbol preceding a line of text identifies a
selected parameter. The parameter can be changed
by pressing the up and down buttons. The '>'
symbol is shown as long as the value of the
parameter currently used is the same as the value
shown in the display.
'▲▼'
The up and down symbols shown in the right side
of the display (up is shown in the first line and
down is shown in the last line) indicates that the
current menu consists of more than 4 menu items. It
is therefore necessary to use the up and down
buttons to leaf through menu items.
Connectors
Headphone Connectors
A mini jack and a standard jack are located on the
front plate for connecting a headphone for listening
to the Floor language or one of the interpreted
languages.
Audio Output A to H
On the back are located 8 XLR 3P connectors, each
supplying transformer balanced audio signal from
each of the 8 channels.
The outputs can be used for tape recording purpose
i.e. or for connecting a digital infrared transmitter
like DT6008, DT 6032 or analogue infrared
transmitter IT 6108 for wireless transmission of the
interpreted languages.
DCS-LAN connector
Two RJ45 sockets are located at the back of the unit
for connecting to the previous unit like the CU
6005/6010 Central Unit or any other unit with a
DCS LAN connector and to the next unit like an IS
6132 Interpreter set, CS 6032 Channel Selector,
DM/CM 6xxx Conference Unit.

Setup

Set-up menu
The user can change the settings for the output
channels by entering the Set-up menu. This is done
by pressing the MENU button:
-Channel setup
- Volume setup
-Headphone setup
-Communication status
The menu is scrolled one line up or down by
pressing the up/down arrow keys. If for example ▼
is pressed the display will reveal the next menu
item at the last line.
-Volume setup
-Headphone setup
-Communication status
-Ver. and serial no.
The menu "wraps around" when the last menu item
is reached at the bottom making "Language" the
last entry in the display.
The whole list contains the following entries:
Channel setup
Volume setup
Headphone setup
Communication status
Ver. and serial no
Clipboard
Original Attenuation
Manual 01 18 04440
User Manual
▲
▼
▲
▼
9