Connections - Extron electronics FOX USB Tx (SM) User Manual

Connections

POWER
12V
0.3A MAX
1
Figure 3.
a
b
c
Tx Rx
HOST
OPTICAL
2 3
Rear Panel Connectors
Power input connector — Connect external power supplies to these 2-pole,
3.5 mm captive screw connectors. If the USB port of a connected PC or laptop is capable
of providing USB power, an external supply for the transmitter is not required.
ATTENTIONS: • Always use a power supply supplied by or specified by Extron for use
with the FOX USB Extender Series. Use of an unauthorized power
supply voids all regulatory compliance certification and may cause
damage to the supply and the FOX USB Extenders.
• Unless otherwise stated, the AC/DC adapters are not suitable for
use in air handling spaces or in wall cavities. The power supply is
to be located within the same vicinity as the Extron AV processing
equipment in an ordinary location, Pollution Degree 2, secured to
the equipment rack within the dedicated closet, podium or desk.
• The installation must always be in accordance with applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75
and the Canadian Electrical Code part 1, section 16. The power
supply shall not be permanently fixed to building structure or similar
structure.
USB host connector — This USB Type A connector supports a computer host. Do
not connect a device at this time; see "Startup" on page 7.
Fiber optic connectors and LEDs — Connect two fiber optic
cables between the LC connectors on the transmitter and receiver.
Connect each Tx port to the Rx port on the opposite unit (see the
drawing at right).
WARNING:
These units output continuous invisible light, which
may be harmful to the eyes; use with caution. For
additional safety, plug the attached dust caps into
the optical transceivers when the fiber cable is
unplugged.
NOTE:
Use the proper fiber cable for your transmitter and
receiver pair. Typically, singlemode fiber has a yellow jacket
and multimode cable has an orange or aqua jacket.
Tx Link and Rx Link LEDs — When lit, the link is active (light is present, either
transmitted or received).
POWER Tx Rx
BYPASS
12V
1.0A MAX
EMULATION
OPTICAL
4 1 3
FOX USB Extender • Installation and Operation
HUB
1
3
2
4
5
Rx
Tx
OPTICAL
Transmitter
Receiver
Tx Rx
OPTICAL
5