Transmitting A Group Call - Standard Horizon HX850S Owner's Manual

To enter the desired number and move one space to
the right press the [ CALL ( ENT ) MENU ] key. Repeat this
procedure until all nine space of the MMSI number are
entered.
11. If a mistake was made entering in the MMSI number repeatedly press the
[ H/L ( )] key until the wrong number is selected, then press the [ ] / [ ]
key to correct the entry.
12. To store the data entered, press and hold the [ CALL ( ENT ) MENU ] key.
13. To enter another Group Address, repeat steps 5 through 12.
14. Press the [ CLR ( MEM )] key twice to return to the "Setup Menu
the [ CLR ( MEM )] key again to return to radio operation.

7.7.2 TRANSMITTING A GROUP CALL

Pre-Programmable Calling
1. Press the [ CALL ( ENT ) MENU ] key. The "DSC Call
Menu" will appear.
Menu Menu
Menu Menu
2. Press the [
cancel, press the [ CLR ( MEM )] key.)
3. Press the [ CALL ( ENT ) MENU ] key. The transceiver will
beep, and the "Group Call
4. Press the [ ] / [ ] key to select "Group
contact.
5. Press the [ CALL ( ENT ) MENU ] key, then press the [ ]
/ [ ] key to select the operating channel you
want to communicate on and press the
[ CALL ( ENT ) MENU ] key.
6. Press the [ CALL ( ENT ) MENU ] key again to
transmit the Group Call signal.
7. When the Group Call signal is sent, the display
will be as shown in the illustration at the right.
8. After the GROUP CALL is transmitted, all the
radios in the group will switch to the designated
channel.
9. Listen to the channel to make sure it is not busy, then
press the PTT switch and call the other vessels you desire to communi-
cate with.
HX850S
] / [ ] key to select "Group
Group Call" directory will appear.
Group Call Group Call
Group Call
Setup Menu", then press
Setup Menu Setup Menu
Setup Menu
DSC Call DSC Call
DSC Call DSC Call
Group". (To
Group Group
Group
Group" you want to
Group Group Group
Page 45