Programming The Mmsi - Standard Horizon HX850S Owner's Manual

7.2.2 PROGRAMMING THE MMSI

A user MMSI can be inputted only once. Therefore please be careful
not to input the incorrect MMSI number. If the user needs to change the
MMSI number after it has been entered, the radio will have to be re-
turned to Factory Service. Refer to the section "10.3 FACTORY SER-
VICE".
1. Press and hold down the [ CALL ( ENT ) MENU ]
key until the "Setup Menu
2. Press the [ ] key to select "DSC Setup
3. Press the [ CALL ( ENT ) MENU ] key, then select
User MMSI" with the [ ] / [ ] key.
"User MMSI
User MMSI User MMSI
User MMSI
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select the first number
o f y o u r
[ CALL ( ENT ) MENU ] key to step to the next num-
ber.
6. Repeat step 5 to set your MMSI (nine digits).
7. If a mistake was made entering, repeatedly press
the [ H/L ( )] key until the wrong number is selected,
then press the [ ] / [ ] key to correct entry.
8. When finished programming the number, press and
hold the [ CALL ( ENT ) MENU ] key. A confirmation mes-
sage will appear on the display. Set your MMSI num-
ber again, then press and hold the [ CALL ( ENT ) MENU ]
key.
9. Press the [ CALL ( ENT ) MENU ] key to store the MMSI
number in memory.
10. Press the [ CLR ( MEM )] key twice to return to radio op-
eration.
Page 32
WARNING
Setup Menu" appears.
Setup Menu Setup Menu Setup Menu
DSC Setup" menu.
DSC Setup DSC Setup
DSC Setup
M M S I , t h e n p r e s s t h e
HX850S