Flow; Port Number; Table 8-3. Interface Mode Options; Table 8-4. Flow Control Options - Lantronix Micro125 User Manual

Flow

Flow control sets the local handshaking method for stopping serial input/output.
Use the following table to select flow control options:

Port Number

The setting represents the source port number in TCP connections. It is the number that
identifies the channel for remote initiating connections.
The default setting for Port 1 is 10001. The range is 1-65535, except for the following
reserved port numbers:
WARNING:
for this setting as incorrect operation may result.
Use Port 0 for the outgoing local port to change with each connection. The port range is
50,000 to 59,999. Each subsequent connection increments the number by 1 (it wraps back
around to 50,000).
Only use this automatic port increment feature to initiate a connection using TCP. Set the port
to a non-zero value when the unit is in a passive mode or when using UDP instead of TCP.
Micro125 User Guide

Table 8-3. Interface Mode Options

I/F Mode Option 7
RS-422 4-wire
RS-485 2-wire
Flow (00) ? _

Table 8-4. Flow Control Options

Flow Control Option
No flow control
XON/XOFF flow control
Hardware handshake with RTS/CTS lines
XON/XOFF pass characters to host
Port No (10001) ? _

Table 8-5. Reserved Port Numbers

Port Numbers Reserved for
1 – 1024 Reserved (well known ports)
9999 Telnet setup
14000-14009
Reserved for Redirector
30704 Reserved (77F0h)
30718
Reserved (77FEh)
We recommend that you not use the reserved port numbers
8: Setup Mode: Channel Configuration
6 5 4 3 2 1 0
0 1
1 1
Hex
00
01
02
05
43