Installing An Interface Expansion Board; Installing An Interface Board - Fujitsu Print partner 14 AV User Manual

Installing an Interface Expansion Board

Installing an
Interface
Expansion Board
4-4
The printer's standard interface is parallel. The available optional
interfaces are serial, LocalTalk, and Ethernet. If your computer cannot
use a parallel port for your printer or the location of your printer is
distant from the computer, you can use the serial port, LocalTalk port, or
Ethernet port of the computer to connect your printer. Fujitsu offers the
optional serial interface (RS-232C/422A) board, LocalTalk board, and
Ethernet board C for these purposes.
Notice:
When sharing the printer among multiple computers, setting the I/O
time-out short may cause a printing problem.
LocalTalk interface board

Installing an Interface Board

Remove
the cover
Secure
screws
(Example: serial interface)
Ethernet interface board
1. To install an interface board,
first make sure the printer is
turned off. Remove the
interface board slot cover
from the back right of the
printer.
2. Hold the board with the parts
mounting side left. Slide the
board into the empty
interface slot using the
guides, and push it until it
stops. Secure the board by the
two screws supplied with it.
Serial interface board
User's Manual