Hyundai 2000 Accent Owner's Manual page 66

H920C01B-GAT
1. POWER ON-OFF/VOLUME
CONTROL KNOB
The radio unit may be operated when the igni-
tion key is in the "ACC" or "ON" position. The
clock will be displayed automatically, although
the radio unit has gone out. Press the button to
switch the power on. The LCD shows the radio
frequency in the radio rnode or the CD track
indicator in the CD mode. To switch the power
off, press the button again.
VOLUME Control
Rotate the knob clockwise to increase the vol-
ume and tum the knob counterclockwise to
reduce the volume.
BALANCE Control
Pull and tum the control knob clockwise to
emphasize right speaker sound. (Left speaker
sound will be attenuated) When the control
knob is tumed counterclockwise, left speaker
sound will be emphasized. (Right speaker sound
will be attenuated)
2. FAD (Fader Control) Knob
Tum the control knob counterclockwise to em-
phasize front speaker sound. (Rear speaker
sound will be attenuated) When the control
knob is tumed clockwise, rear speaker sound
will be emphasized. (Front speaker sound will
be attenuated)
FEATURES OF YOUR HYUNDAI
3. BASS/TREBLE Control Knob
BASS Control Knob
Press to pop the knob out and tum to the left or
right for the desired bass tone.
TREBLE Control Knob
Further pull-lock position of popped-up knob.
Tum to the left or right for the desired treble
tone.
4. BANO Selector
Pressing the E^Sbutton changes the AM, FM1
and FM2 bands. The mode selected is dis-
played on LCD.
5. TUNE (Manual) Select Button
Press the (+) side or (-) side to increase or to
decrease the frequency. With the button held
down for 0.5 sec. or more, the stop signal
(broadcasting radio wave) is ignored and chan-
nel selection continues.
SEEK Operation (Automatic Channel
Selection)
Press the TUNE select button 1 sec or more,
and releasing will automatically tune the next
available station.
When the (+) side is pressed longer than 1
second and releasing will automatically tune
the next higher frequency and when the (-) side
is pressed longer than 1 second and releasing
will automatically tune the next lower frequen-
cy.
6. PRESET STATION SELECT Button
Six (6) stations for AM, FM and FM2 respec-
tively can be preset in the electronic memory
circuit on this unit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be pro-
grammed into the memory of the radio. Then,
by simply pressing the band select button and/
or one of the six station select buttons, you may
recall any of these stations instantly. To pro-
gram the stations, follow these steps:
o Press band selector to set the band for AM,
FM, and FM2.
o Select the desired station to be stored by
seek, scan or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
o Press the station select button for more than
two seconds. A select button indicator will
show in the display indicating which select
button you have depressed. The frequency
display will flash after it has been stored into
the memory. You should then release the
button, and proceed to program the next'
desired station. A total of 18 stations can be
programmed by selecting one AM and two
FM stations per button.
o When completed, any preset station may be
recalled by selecting AM, FM or FM2 band
and the appropriate station button.
1-57