Hyundai 2000 Accent Owner's Manual page 40

B340Q01A-GAT
HEADLIGHT LEVELING OEVICE SYS-
TEM (If Installed)
To adjust the headlight beam level according to
the number of the passengers and the loading
weight in the luggage area, tum the beam
leveling switch.
The higher the number of the switch position,
the lower the headlight beam level. Always
keep the headlight beam at the proper leveling
position, or headlights may dazzle other road
users.
Listed below are the examples of proper switch
settings. For loading conditions other than those
listed below, adjust the switch position so that
the beam level may be the nearest as the
condition obtained according to the list.
FEATURES OF YOUR HYUNDAI
Loading condition
Driver only
Driver + front passenger
Full passengers
(including driver)
Full passengers (including
driver) + full trunk loading
(or light trailer loading)
Driver + full trunk loading
(or maximum trailer loading)
B370A01A-AAT
HAZARD WARNING SYSTEM
The hazard waming system should be used
whenever you find it necessary to stop the car
in a hazardous location. When you must make
such an emergency stop, always pull off the
Switch
road as far as possible.
position
The hazard waming lights are tumed on by
pushing in on the hazard switch. This causes all
0
tum signal lights to blink. The hazard waming
0
lights will operate even though the key is not in
the ignition.
1
To tum the hazard waming lights off, push in on
the switch a second time.
2
B3BOA01A-AAT
REAR WINDOW DEFROSTER
SWITCH
3
The rear window defroster is tumed on by
pushing in on the switch. To tum the defroster
off, push in on the switch a second time. The
rear window defroster automatically tums itself
off after about 15 minutes. To restart the de-
froster cycle, push in on the switch again after
it has tumed itself off.
1-31