Hyundai 2000 Accent Owner's Manual page 24

8230601E-GAT
Using a Child Restraint System
Cover, Child Restraint
Hook Holder
Bolt, Holder (5/16'-30mm)
Washer, Conical Spring
Holder, Child Restraint Hook
Spacer, Child Restraint
Hook Holder
Retainer Washer
For small children and babies, the use of a child
seat or infant seat is strongly recommended.
This child seat or infant seat should be of
appropriate size for the child and should be
installed in accordance with the manufacturer's
instructions. It is further recommended thatthe
seat be placed in the vehicle's rear seat since
this can make an important contributton to safety.
Your vehicle is provided with three holes for
installing the child restraint anchor fittings. The
anchorage nut is welded beneath the sheet
metal to permit installation of a child restraint
anchorage fitting for a child seat, as shown in
the illustration.
FEATURES OF YOUR HYUNDAI
B230C01A-QAT
Child Restraint Hook Holder Nut Loca-
tion (4 Door)
Rear seat package tray
SSAHOOB
Front of Vehicle
Three child restraint hook holder nuts are lo-
cated on the rear seat package tray and the
anchor holes are covered with plugs.
If you want to install a child restraint system
hook holder, remove one of the 3 anchorage
trim plugs from the rear seat package tray trim,
then install the hook holder for your child re-
straint system with the bolt and spacer and
torque to 1.7-2.6 kgf.m (12.3-18.8 Ib.ft, 16.7-
25.5 N.m)
B230E01A-GAT
Anchorages
Child Restraint Hook Holder Nut Loca-
tion (3/5 Door)
Blanking covers
Covering shelf
Tether strap hook
Back panel —
Front of Vehicle