Hyundai 2000 Accent Owner's Manual page 21

WARNING:
o Thehelghtadjustermustbelnthelocked
position whenever the vehicle is moving.
o Themisadjustmentof heightoftheshoul-
der belt could reduce the effectiveness
of the seat belt in a crash.
B180A01A-GAT
SEAT BELTS-Driver's 3-Point System
with Emergency Locking Retractor
To Fasten Your Belt
To fasten your seat belt, pull it out of the
retractor and insert the metal tab into the buck-
le. There will be an audible "click" when the tab
locks into the buckle.
The seat belt automatically adjusts to the prop-
er length only after the lap belt is adjusted
manually so that it fits snugly around your hips.
If you lean forward in a slow, easy motion, the
belt will extend and let you move around. If
FEATURES OF YOUR HYUNDAI
there is a sudden stop or impact, however, the
belt will lock into position. It will also lock if you
try to lean forward too quickly. Check to make
sure that the belt is property locked and that the
belt is not twisted.
B200A01S-QAT
Adjusting Your Seat Belt
You should place the belt as low as possible on
your hips, not on your waist. If the belt is located
too high on your body, you could slide under it
in case of accident or a sudden stop. This could
result of death, serious injury or property dam-
age. Both arms should not be under or over the
belt. Rather, one should be over and the other
under, as shown in the illustration.
Never wear the seat belt under the arm nearest
the door.
B210A01A-AAT
To Release the Seat Belt
The seat belt is released by presslng the re-
lease button in the locking buckle. When it is
released, the belt should automatically draw
back into the retractor.
If this does not happen, check the belt to be
sure it is not twisted, then try again.
(R.
Ta
rrr
ai
b)
to